Skip to main content

Migration guide for updating to new versions

General information​

After installing/deploying the new version opentalk-controller fix-acl must be run in order to update ACLs to match the newest version whenever new endpoints were added for already present resources. However, even if no endpoints were added, simply running the command does no harm.

Updating to OpenTalk Controller v0.16.0​

Janus can now be connected to via websocket​

The OpenTalk controller now can be configured to connect to Janus directly via a websocket connection instead of using rabbitmq in-between.

See the configuration documentation.

Updating to OpenTalk Controller v0.15.0​

Redis is only required for clustered operation​

Since v0.15.0 of the OpenTalk controller, the usage of a [Redis](core/ redis.md) service is only required for synchronizing between nodes when the controller should run in clustered mode. If the service should only be provided by a single node, then the controller can run in standalone mode now by removing the [redis] section from the configuration entirely.

Updating to OpenTalk Controller v0.9.0​

Removal of server-side speaker detection​

The audio level detection is no longer performed by the MCU (Multipoint Control Unit, in this case the Janus Media Server), therefore the corresponding settings are deprecated.

Deprecated settings in the configuration file are:

  • room_server.speaker_focus_packets
  • room_server.speaker_focus_level

Corresponding entries should be removed from the configuration file. If one of the settings is found in the configuration file, a warning is printed out as information for the administrator.